Pancake Die 2000 - Heartleaf

This spacer is 4.5'' x 7.75'' and 1'' thick.

This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

This is a collection of the most popular and necessary accessories for the Rincon Press.

Copper sheets (5 pieces of 18 gauge) cut to the size of our rolling mill pattern plates! Copper Sheet 18 Gauge 5 PIECES - 2" x 7". Fully hard CDA # 110; 99.9% PURE.

Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. 3" x 2-1/4", 1/4" thick. Die itself 5" x 4.25" Must be used with a large sheet of urethane (available separately). Designed to coordinate with pd2000 ***Will not fit in the discontinued Potter USA medium press***

Tool Steel Magnetic Pusher to be used on impression dies in a hydraulic press. 2" diameter. Approx. 3/4" tall, including 1/4" tool steel face. Attaches to upper platen with a magnet.