3 Inch Urethane - 60 Durometer

3 inch diameter x 1 inch thick, 90/95 durometer urethane insert. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.

3 inch diameter x 2 inch height contained urethane with metal pusher (pusher not pictured). Comes with 95 durometer urethane. ***You can use this with 2 inch silhouette dies, BUT, the impression will not be able to get as deep as with the 2 x 2 contained urethane. NOT for use with impression dies.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.