3 x 2 contained urethane w/pusher

2 x 2 contained urethane with pusher for use with our standard, 2 inch silhouette dies. Comes with container, 95 durometer urethane and metal pusher. NOT for use with impression dies.

Bracelet Former Kit to be used with 20 Ton hydraulic press. Our Bracelet Former Frame is now magnetic - no adapter plate needed! Great to use our bracelet pancake dies to cut the metal first, then form with our Bracelet Former Kit, for quick cuff bracelets.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

This press does NOT include the hydraulic jack or pressure gauge. Outer Dimensions: 23 inches high x 16.5 inches wide x 7 inches long. Lower platen working area is 6" x 8".