Customers who bought this item also bought
Pattern Plate RMP044 William Rice's Hummingbird Bracelet
RMP044
Enjoy William Rice's engraving of his iconic hummingbird --- fit for Pancake Die B001 B! Measures at 1 1/4" x 6 3/8" or 32mm x 165mm Plate Thickness: ~2.5mm. Customer demo: Melany Luna Sarafis
$39.00
Copper Sheet 18 Gauge 5" x 8"
CS 18
Copper Sheet 18 Gauge 5" x8". Fully hard CDA # 110; 99.9% PURE.
$15.00
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Copper Sheet 20 Gauge 5" x 8"
CS 20
Plain copper sheet, 20 gauge. 5 inch x 8 inch piece CDA #110; 99.9% pure
$14.00
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.75
