Pattern Plate RMP044 William Rice's Hummingbird Bracelet

Our bracelet pancake dies are back and redesigned to better cut and fit in the Rincon Press!

Design + border: 1-9/16"H x 6-1/2"L Design only: 1-3/16"H x 6-1/16"L Hand-engraved by Bill Rice

This plate is designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W Plate Thickness: ~2.5mm Design Size: 6-1/2" L x 1-1/2" W

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

3/4" wide x 5 1/2" long Plate Thickness: ~2.5mm

Design: 1-5/8" x 5-3/8" Plate Thickness: ~2.5mm