Sterling Silver Stamping "Sunflower"

Use this die to trim bracelet ends with a rounded shape. Start with a strip of metal no wider than 1-1/4" and trim rounded ends for a bracelet blank in whatever length you like!

Approx. 16 gauge (Due to supply challenges, gauge may vary.) Design: 1-1/2” x 5/8” NOTE: Each stamping is made in house, one at a time, using vintage tools and processes. The detail in each stamping may vary, and a stamping with less detail is not considered defective.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.