Pancake Die 1922 Bracelet End Cutter 1.25

Approx. 16 gauge (Due to supply challenges, gauge may vary.) Design: 5/8" diameter NOTE: Each stamping is made in house, one at a time, using vintage tools and processes. The detail in each stamping may vary, and a stamping with less detail is not considered defective

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Copper Sheet 18 Gauge 5" x8". Fully hard CDA # 110; 99.9% PURE.

Use this die to trim bracelet ends with a rounded shape. Start with a strip of metal no wider than 3/4" and trim rounded ends for a bracelet blank in whatever length you like!

Use this die to trim bracelet ends with a rounded shape. Start with a strip of metal no wider than 1" and trim rounded ends for a bracelet blank in whatever length you like!