Pattern Plate RMP181 Island Dreams

Design + border: 1-9/16"H x 6-1/2"L Design only: 1-3/16"H x 6-1/16"L Hand-engraved by Bill Rice

Design Size: approximately 2-15/16" x 5/16" Designed for use in a rolling mill.

Design Size: approximately 2-7/8" x 1/4" Designed for use in a rolling mill.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Bracelet Die 949.1 Wide Taper 6 1/2" x 1 5/8" ***Will not fit in the discontinued Potter USA medium press***