LAST CALL! Pancake Die 1336A Small Flag

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Each circle is 1" diameter Plate Thickness: ~2.5mm

6" long, tapered 7/8" to 1 3/4" wide. Square ends. Largest (length and width) of our bracelet dies. Use this bracelet die with any of our bracelet formers.rnSave a step when making a bracelet - just use a pancake die instead of sawing out the blank piece *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS *** Outer Dimensions; 4 7/8" Tall x 8" Wide

Comes with the left and right variants of four Sonoran plants. Plate Thickness: ~2.5mm