Circle Mandala Quartet Pattern Plate RMP030

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

18 gauge Fine Silver Sheet, 1 oz.   2" x 2" Measurements are approximate. Metal type: Fine silver Karat/purity: 999 Hardness: Fully hardGauge/thickness: 18 ga. Form: Sheet

Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.

20 gauge  fine silver stamped from antique die. Measures 1 7/16" in diameter or 36mm Diameter These pieces are finished in the photo but will not be shipped out oxidized or finished! Comes in uncut 1 ounce silver

This plate is designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W x 1/8” Thickness Design Size: 1-1/2" Diameter (each mandala)