Pancake Die Bundle Bow

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

Design: 5/8" x 3/8" Die Set Includes: Die Top, with precision-welded cutter Die Bottom, with precision-registered center hole and metal guide marks on bottom- and right-side edges to assist in lining up metal in the die Urethane: Specific to each die set; not interchangeable with other designs. Color may vary. The components of each Die set are not interchangeable with other die sets, but all can be used with a single, standard Die Shoe. MUST BE USED WITH THE FSS DIE SHOE (available separately) Watch Kevin demonstrate how to use this die: https://youtu.be/7Gl-ShVKtlk

Each cuff is approximately 6.5" long. The bracelet is made from 16-gauge copper that has been coated with a heavy-duty industrial silver plating (with a nickel base layer), similar to the heavy silver-plate of silverware. CANNOT be soldered, filed, or sanded (plating will be removed). CAN be lightly polished, slightly re-formed with non-marring forming tools, and patinated. Bracelets are all made from the same pattern but because they are rolled by hand they may have some inconsistencies and not be exactly identical. The inside surface and edges of the cuff may have small dings, scratches, and other imperfections; these are not considered defects. NOTE: This batch is NOT stamped "Silver Plated." Width: 1/2"