Pancake Die 1688 - Pod

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Our redesigned pancake dies are here! Die: 4-11/16" H x 3" W Working Area: 1-5/8" H x 2-3/4" W

Pancake Die 710 Large Long Oval 2 1/4" long x 3/4" wide

This small, five-petaled flower pancake design is just smaller than a quarter. Design: 3/4" diameter

This die must be used in a hydraulic press. Design: 13/16" x 3/4" (20mm x 19mm). Overall die measures 3-3/8" x 5-3/16".

Overall Design Size: approximately 2" x 7" Designed for use in a rolling mill.