Pancake Die 1527-TB Coffin Box Kit

Brand new! Use this tool to make shallow domed forms, such as trinket dishes, lockets, small containers, etc. Coordinates with the Coffin Pancake Die. Design: 3" x 2" Die Itself: 5"x 4" Thickness: 1/4" thick. Must be used with a large sheet of urethane (available separately). ***Will not fit in the discontinued Potter USA medium press***

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Design: 3-1/2" x 2-1/2" Die itself: 8" x 4-1/2" Coordinated to work with the Coffin Dish Former Silhouette Die. ***Will not fit in the discontinued Potter USA medium press***

For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

1522-B Triangle Box Base: 1 1/2" Base x 3/4" Tall Walls 1522-T Triangle Box Top: 1 9/16" Base x 1/4" Tall Walls * Makes finished box bottom that is 1 1/2" across and 3/4" tall and the lid is 1 1/2" across and 1/4" deep Designed to be used with 20 GAUGE SHEET METAL.