Impression Die Little Feather

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Approx. 16 gauge (Due to supply challenges, gauge may vary.) Design: 5/8” x 1” NOTE: Each stamping is made in house, one at a time, using vintage tools and processes. The detail in each stamping may vary, and a stamping with less detail is not considered defective.

This spacer is 4.5'' x 7.75'' and 1'' thick.

Design your own impression die! Made with special die-carving steel that is easy to carve. Use files, gravers, burs, or chasing tools to carve your own design in the negative.