Customers who bought this item also bought
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4” x 7.75” x 1”)
Al-Spacer
This spacer is 4'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$35.95
Pancake Die 000 Blank
PD 000
Our redesigned pancake dies are here! Die: 4-11/16" H x 3" W Working Area: 1-5/8" H x 2-3/4" W
$23.00
Pancake Die Bracelet B031 Basic Cuff Bracelet
PD B031
1.5" H x 6" W. Die itself is 7 7/16" x 4 29/32". Use die sideways in press with extended platens or press about 1/2 the die at a time. ***Will not fit in the discontinued Potter USA medium press***
$44.25 $37.61
Aluminum Spacer (4.5" x 7.75"x1/2")
Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50