Fine Silver Sheet 20 Gauge 4 x 2

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.

Tool Steel Magnetic Pusher to be used on impression dies in a hydraulic press. 2" diameter. Approx. 3/4" tall, including 1/4" tool steel face. Attaches to upper platen with a magnet.

Each cuff is approximately 6.5" long. The bracelet is made from 16-gauge copper that has been coated with a heavy-duty industrial silver plating (with a nickel base layer), similar to the heavy silver-plate of silverware. CANNOT be soldered, filed, or sanded (plating will be removed). CAN be lightly polished, slightly re-formed with non-marring forming tools, and patinated. Bracelets are all made from the same pattern but because they are rolled by hand they may have some inconsistencies and not be exactly identical. The inside surface and edges of the cuff may have small dings, scratches, and other imperfections; these are not considered defects. NOTE: This batch is NOT stamped "Silver Plated." Width: 5/8"