Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Feather 2 RMP024

    $55.00
    This plate is designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W x 1/8” Thickness Design Size: 5" W x 1-1/4" L
    SKU: RMP024
    Availability: In stock

    Designed to be used in a rolling mill with annealed, non-ferrous metal.

    Plate Size: ~7" L x 2" W x 1/8” Thickness
    Design Size: 5" W x 1-1/4" L

    The plate may be slightly curved when it arrives, and that’s okay! It will not harm your rolling mill, as the plates will curve with use anyway. The metal used for the plate is softer than the rolls of a rolling mill and will not damage them. It is also safe to use in a press.

    NOTE: It is possible to use these rolling mill plates with a hydraulic press, but the results won’t be the same as with the rolling mill; we only recommend a rolling mill. If using a press, use a single, small piece of urethane and press multiple times; you'll only be able to get a small section of the design at a time.

    Designed to be used in a rolling mill with annealed, non-ferrous metal.

    Plate Size: ~7" L x 2" W x 1/8” Thickness
    Design Size: 5" W x 1-1/4" L

    The plate may be slightly curved when it arrives, and that’s okay! It will not harm your rolling mill, as the plates will curve with use anyway. The metal used for the plate is softer than the rolls of a rolling mill and will not damage them. It is also safe to use in a press.

    NOTE: It is possible to use these rolling mill plates with a hydraulic press, but the results won’t be the same as with the rolling mill; we only recommend a rolling mill. If using a press, use a single, small piece of urethane and press multiple times; you'll only be able to get a small section of the design at a time.

    Product tags
    Customers who bought this item also bought

    Feather 1 RMP023

    $55.00
    This plate is designed to be used in a rolling mill with annealed, non-ferrous metal. Plate Size: ~7" L x 2" W x 1/8” Thickness Design Size: 5-7/16" L x 1-1/4" W

    ***LIMITED RUN***Impression Die Blooming Vine Block

    $60.00
    1 1/8" x 1 1/8" or 28.5mm x 28.5mm

    Paris Orchard Impression Die

    $55.00
    It's here for a limited time! This fruit-bearing tree was hand-carved in Paris around the turn of the century. Available only through Jan. 31! 2" puck Image is 1-1/4"W x 1-1/8"H

    Copper Sheet 20 Gauge 5" x 8"

    $8.75
    Plain copper sheet, 20 gauge.  5 inch x 8 inch piece CDA #110; 99.9% pure

    Urethane Pieces

    $7.00
    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.