Tool Steel Pusher

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

This die must be used in a hydraulic press. You MUST watch video on how to use this die. See below in Longer description. This die measures 1 1/2 around A Small Tool Steel Pusher is included with this product. The Small Tool Steel Pusher is 1" Diameter x 1" Tall. Matching Pancake Die can be found at: Pancake Die 1300 Mandala

Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.

2 x 2 contained urethane with pusher for use with our standard, 2 inch silhouette dies. Comes with container, 95 durometer urethane and metal pusher. NOT for use with impression dies.