Tool Organizer

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This bezel die tool will create as many 5mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. fine silver. The size of disc you start with for the 5mm bezel die is a 10mm disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.

2" x ~6-7/8".

1834: Left: 19.8 x 14mm. Right: 14.3 x 16.5mm. Die: 5-1/8" x 3-1/2". 1835: Left: 16.8 x 16.5mm. Right: 20.6 x 13mm. Die: 5-1/8" x 3-3/8".

Use this die to trim bracelet ends with a rounded shape. Start with a strip of metal no wider than 1.5" and trim rounded ends for a bracelet blank in whatever length you like!