Pancake Die NC3in North Carolina Ornament

State: 1-1/8" x 3". Die: 6-1/8" x 5".
SKU: PD NC3in

State: 1-1/8" x 3".
Die: 6-1/8" x 5".

  • Designed for use in a 20-ton hydraulic press
  • Use ONLY with full-hard, non-ferrous metal (do not anneal your metal)
  • Acceptable metal gauges: 16-22 gauge
  • Cutting edges are straight, not at an angle
  • Shipped pre-sprung
$32.95
increase decrease
Availability: In stock
Ship to
*
*
Shipping Method
Name
Estimated Delivery
Price
No shipping options

State: 1-1/8" x 3".
Die: 6-1/8" x 5".

  • Designed for use in a 20-ton hydraulic press
  • Use ONLY with full-hard, non-ferrous metal (do not anneal your metal)
  • Acceptable metal gauges: 16-22 gauge
  • Cutting edges are straight, not at an angle
  • Shipped pre-sprung
Customers who bought this item also bought

Pattern Plate RMP164 Insect Wings

RMP164
This pattern plate was designed to coordinate with some of our bug body impression dies and works well with shotplate die SKU: Bug1 The plate measures approximately 2" x 7", see the photos for measurements of individual wings. Designed for use in a rolling mill.
$39.00

Aluminum Spacer (4.5" x 7.75"x1/2")

Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50

Pancake Die 1778 Arrow Leaf

PD1778
1-7/16" x 1-1/16". Die: 6" x 3-3/8". Matches RMP296
$27.50

Tortolita - Aluminum Spacers Set of 2

TORT-Al-Spacer
THESE ARE SMALL AND ONLY INTENDED FOR THE TORTOLITA PRESS. 2 Aluminum Spacers machined to fit inside the Tortolita Press. 3" x 2-7/16 x 1/2"
$15.00