Pancake Die 1644 Allium Arabesque

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This die must be used in a hydraulic press. This die measures 1 1/2" wide x 1 3/16" tall

This die must be used in a hydraulic press. This die measures 1 1/4" x 1 7/16"

Design: 1-1/4"W x 1" Designed by Gina Copanzzi

No rolling mill or press? No problem! Design Size: 1-1/8" x 6-5/16" 16 gauge Overall Strip Length: varies NOTE: Strip will be slightly curved, and design may not be centered on the copper strip. Copper strip is sold unfinished and may have scratches and marks on its surface that you will need to remove. Design may extend off the edges of the sheet and may be off center; this is not considered a defect.