Pancake Die 1631 7-Petal Daisy

This die must be used in a hydraulic press. This die is coordinated to work with the cone design on Pattern Plate RMP167 Egyptian Revival. Makes a cone with a 12mm wide end and 6mm narrow end. Shape measures 1-7/16" x11/16". Overall die measures 5-1/16" x 3-3/8".

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.

You asked for small pancake dies, and we listened! This mini meadow flower is only 3/8" wide. Due to its size, it requires care when using it to ensure it stays aligned.