Products specifications
| Attribute name | Attribute value |
|---|---|
| Press Compatibility | Tortolita, Rincon |
Customers who bought this item also bought
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4.5" x 7.75"x1/2")
Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50
Copper Sheet 20 Gauge 5" x 8"
CS 20
Plain copper sheet, 20 gauge. 5 inch x 8 inch piece Fully hard CDA #110; 99.9% pure
$17.00