Products specifications
| Attribute name | Attribute value |
|---|---|
| Press Compatibility | Rincon |
Customers who bought this item also bought
Bezel Die Tool 8mm Round
BDP-R008
This bezel die tool will create as many 8mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. nonferrous metal. The size of disc you start with for the 8mm bezel die is a 1/2" disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.
$86.00
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.50
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50