Impression Die Feather Bracelet

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This may take longer to receive than other impression dies. It requires us to use a non-standard size of steel to make the impression die. From the Frank Morrow Co. in Providence, Rhode Island.

This special bracelet impression die was hand selected by Kevin from our Frank Murrow collection. Kevin Potter is making a full-sized bracelet hub. Your design will be made of a stamp-and-repeat version of the one pictured.

This may take longer to receive than other impression dies. It requires us to use a non-standard size of steel to make the impression die. From Providence, Rhode Island.