Customers who bought this item also bought
Aluminum Spacer (4.5" x 7.75"x1/2")
Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Urethane Sheet for Dish Former Silhouette Dies
DFUrethane
For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.
$20.00
Bezel Die Tool 6mm Round
BDP-R006
This bezel die tool will create as many 6mm round bezels as you'd like to press in your hydraulic press. Recommended for 22 ga. fine silver. The size of disc you start with for the 6mm bezel die is a 12mm disc. The interior bezel height after pressing is ~3mm. You can adjust the height to fit your specific stone.
$86.00