Customers who bought this item also bought
Aluminum Spacer (4.5” x 7.75” x 1”)
Al-Spacer
This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$39.75
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Urethane Sheet for Dish Former Silhouette Dies
DFUrethane
For use only with Dish Former Silhouette Dies. ~4.75" x 4.75" 60-70 durometer. Color may vary. 1/4" thick.
$20.00
Pattern Plate RMP157 Band Ring Plate 1
RMP157
This listing is for one pattern plate; see the second photo for explanation of the three items in the photo. Each Ring Design is : 2 7/8" long x 3/8" wide
$39.00
Wire Former Mount
WFMount
This mount is meant to be used with our wire-forming tools. Each wire-forming tool includes two mounting holes that fit securely onto the pegs in this mount. The mount has two holes where it can be secured to a work surface with screws. Once attached to a work surface, each wire-forming tool can be dropped down onto the mount and held securely in place with the pegs. Changing out tools is as easy as lifting the wire former off the pegs and replacing it with a different wire former. The mount measures 5" x 2". Wire forming tools SOLD SEPARATELY.
$25.00
Aluminum Spacer (4.5" x 7.75"x1/2")
Al-SpacerThin
This spacer measures 7-3/4" in length, 4-1/2" in width, and is 1/2" thick. It is nonmagnetic. Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$28.50