Customers who bought this item also bought
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4” x 7.75” x 1”)
Al-Spacer
This spacer is 4'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$35.95
Riveted Shield Earrings Kit
PD1491+RMP135+Instructions
Learn how to make these Riveted Shield Earrings with a tube-lined hole and ear wire that stays put! In this kit, you will receive a versatile, shield pancake die, an intricate linen-texture pattern plate, and instructions on how to make the earrings shown in the listing! BONUS bracelet instructions included! Pancake Die: 7/8" x 9/16" (22 x 14mm). Pattern Plate: 2" x 7-7/8", approx. 1/8" thick.
$50.00
Tool Steel Magnetic Ring Pusher
Pusher 2 - Ring
This tool steel ring pusher will give you greater detail in your rings when used on impression dies in a hydraulic press. Size: 3" x 1-1/2"
$45.00
Pattern Plate RMP142 Extra-Skinny Taper Bill Rice Hummingbird Plate
RMP142
Hand-carved by renowned engraver, Bill Rice, this extra-skinny version of his popular hummingbird design pairs well with pancake die B019. This listing is for one pattern plate; see the second photo for explanation of the three items in the photo. ~3/4" x 6" (18.5mm x 15.1cm)
$39.00
2" Magnetic Tool Steel Pusher
Pusher-1
Tool Steel Magnetic Pusher to be used on impression dies in a hydraulic press. 2" diameter. Approx. 3/4" tall, including 1/4" tool steel face. Attaches to upper platen with a magnet.
$35.00