Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Stamp Border Holder

    $68.00
    1.5 inches tall x 2.75 inches wide. Opening to place stamp is 3/8 inches and has three bolts to tighten it in place. Two strong magnets are placed in top of holder so it will attach to the top of any hydraulic press and stay in place. See video in full description.
    SKU: Stamp Border Holder
    Availability: In stock

    Metal Stamp Border Die Holder (Stamp in photo not included)

    1.5 inches tall x 2.75 inches wide.

    Opening to place stamp is 3/8 inches and has three bolts to tighten it in place. Two strong magnets are placed in top of holder so it will attach to the top of any hydraulic press and stay in place.

    Can also be used with Wire Die Pusher to apply even pressure on certain ring impression dies.

    Photo of Stamp Border Holder with Wire Die Pusher (sold separately)

    Stamp Holder with Wire Die Pusher

    Metal Stamp Border Die Holder (Stamp in photo not included)

    1.5 inches tall x 2.75 inches wide.

    Opening to place stamp is 3/8 inches and has three bolts to tighten it in place. Two strong magnets are placed in top of holder so it will attach to the top of any hydraulic press and stay in place.

    Can also be used with Wire Die Pusher to apply even pressure on certain ring impression dies.

    Photo of Stamp Border Holder with Wire Die Pusher (sold separately)

    Stamp Holder with Wire Die Pusher

    Customers who bought this item also bought

    Wire Die Pusher

    $9.00
    Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.

    Urethane Pieces

    $5.25 $7.00
    Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

    In stock

    Impression Die Thick Rope Band

    $48.00
    1/4" H x 3 1/4"W or 6mm x 82mm This die must be used in a hydraulic press. This design will run off the edge of the die so that you can feed your metal through to make a continuous pattern.

    6 x 8 Aluminum Spacer

    $32.00
    This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

    Silhouette Die 166 Small Rounded Square

    $14.92 $19.90
    The Outside Diameter of this Die is 2" Silhouette Die - Small rounded Square 5/8 inch long x 1/2 wide