Impression Die Jazzy the Dog

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

Design your own impression die! Made with special die-carving steel that is easy to carve. Use files, gravers, burs, or chasing tools to carve your own design in the negative.

This die must be used in a hydraulic press. This die measures 15/16" around

This die must be used in a hydraulic press. Wont fit in our old style presses. This die measures 6 7/8"long  x1 1/2" wide

Properly heat treated hi carbon steel. For use in Stamp Border Holder to push wire into certain ring impression dies.