Previous productImpression Die Sun Aspis
Next productImpression Die American Bis...

Impression Die Large Cactus

A large cactus impression die from the Parisi Tool & Die Co.
SKU: PT-W138

This impression die is for use in making stampings with a hydraulic press. You will not receive the master hub pictured. Rather, you will receive an inverse impression with which you can make stampings.
Design: 1-5/16" x 5/8"

$64.00
increase decrease
Availability: In stock
Available until: 6/23/2025 7:00 AM
Approximate Time Left:
Ship to
*
*
Shipping Method
Name
Estimated Delivery
Price
No shipping options

This impression die is for use in making stampings with a hydraulic press. You will not receive the master hub pictured. Rather, you will receive an inverse impression with which you can make stampings.
Design: 1-5/16" x 5/8"

Products specifications
Attribute nameAttribute value
Press CompatibilityTortolita, Rincon
Products specifications
Attribute nameAttribute value
Press CompatibilityTortolita, Rincon
Customers who bought this item also bought
Picture of Impression Die Prickly Pear Cactus

Impression Die Prickly Pear Cactus

PT-W127
A prickly pear impression die from the Parisi Tool & Die Co.
$64.00
Picture of Urethane Pieces

Urethane Pieces

UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Picture of Impression Die Stone Arrowhead

Impression Die Stone Arrowhead

FB-U139
An arrowhead carving for pendants and earrings. From Foster & Bailey.
$64.00
Picture of Pattern Plate RMP123 Paisley Pattern

Pattern Plate RMP123 Paisley Pattern

RMP123
Design: Design Size: 2" x 6-3/4"; ~1/8" thick
$39.00
Picture of Aluminum Spacer (4” x 7.75” x 1”)

Aluminum Spacer (4” x 7.75” x 1”)

Al-Spacer
This spacer is 4'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$35.95