Shot Plate English Flag

This is a ring bending die that fits in the bracelet former frame for the hydraulic press. This will allow you to bend heavy gauge ring shanks with ease! TO BE USED WITH THE BRACELET FORMER FRAME. 1 inch diameter

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

5/8" or 16mm Diameter

7/8" H (at highest point) x 3 3/8" W   Narrowest point is 1/8"

3/16" x 3/8" or 5mm x 9.5mm Can be used with a hydraulic press or by placing silver shot into image and then a heavy hammer blow to the metal.