LAST CALL! Pancake Die B032 Leafy Bracelet

This die must be used in a hydraulic press. Wont fit in our old style presses. This die measures 6 7/8"long x1 1/2" wide ***Will not fit in the discontinued Potter USA medium press***

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

1.25"H (in center) x 6.5"W Feather portions are approx 3/4" H x 3 3/4" W (per feather). Center oval is 1.25" H x 15/16" W Die itself is 5 5/16" H x 9.5" W. Must be used sideways in press (perpendicular to press) with extended platens or put in 1/2 way and cut and moved over to cut other 1/2. ***Will not fit in the discontinued Potter USA medium press*** Customer demo: Melissa Reichert-Leyland

This die must be used in a hydraulic press. This die measures 6 1/2" long x 1 13/16" wide Does NOT fit Rincon press or our old medium press.