Customers who bought this item also bought
Small Skinny Synclastic Bracelet Former
Small Skinny Synclastic FORMER
This is for narrow Synclastic Bracelets. 7/8" wide, 1-15/16"" radius. This is for one former, not a set.
$101.50
3 Inch Urethane - 90/95 Durometer
3in ureth 95
3 inch diameter x 1 inch thick, 90/95 durometer urethane insert. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.
$34.25
2 Inch Urethane - 90/95 Durometer
2in ureth 95
2 inch diameter x 1 inch thick urethane, 90/95 durometer. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.
$28.25
Ring Bending Die
RBD
This is a ring bending die that fits in the bracelet former frame for the hydraulic press. This will allow you to bend heavy gauge ring shanks with ease! TO BE USED WITH THE BRACELET FORMER FRAME (sold separately). 1 inch diameter
$54.25
Urethane Pieces
UP
Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.
$8.50
Aluminum Spacer (4” x 7.75” x 1”)
Al-Spacer
This spacer is 4'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.
$35.95