Large Flat Bracelet Former

This measures 1.00" Radius x 1.75" wide This die must be used in a hydraulic press

This spacer is 4.5'' x 7.75'' and 1'' thick.

3 inch diameter x 1 inch thick, 90/95 durometer urethane insert. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

This is a ring bending die that fits in the bracelet former frame for the hydraulic press. This will allow you to bend heavy gauge ring shanks with ease! TO BE USED WITH THE BRACELET FORMER FRAME (sold separately). 1 inch diameter

Now for bangles too! Please read the information below. Frame includes 2 Columns and 1 Beam Beam: 6"L x 3/4"H Columns: 2 1/2"H x 1 5/8"W (top), 2"W (bottom) (Columns you receive may not be tapered as in photo)