Impression Die Ring Top 62

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

1.5" H x 6" W. Die itself is 7 7/16" x 4 29/32". Use die sideways in press with extended platens or press about 1/2 the die at a time. ***Will not fit in the discontinued Potter USA medium press***

This spacer is 4'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

6" long, tapered 7/8" to 1 3/4" wide. Square ends. Largest (length and width) of our bracelet dies. Use this bracelet die with any of our bracelet formers.rnSave a step when making a bracelet - just use a pancake die instead of sawing out the blank piece *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS *** Outer Dimensions; 4 7/8" Tall x 8" Wide

Bracelet Die B007 6 1/4" length, 1 1/2" at each end, 3/4" at narrowest *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Medium tapered bracelet 6" long, widest part 1 1/8" tapering down to 1/2 " This pattern has different sizes, great for layering! *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***