Impression Die Left Swan

This die must be used in a hydraulic press. This die measures 7/8" wide  X 13/16" Tall Swan earring

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This wheat pattern impression die is 2.5 inches (actual pattern) long. The pattern is 3/16th wide. Can be used with a mallet or in the hydraulic press.

15/16" Tall X 1/2" Wide Impression dies should be used with a hydraulic press

This is a set of 4 shot plates Top Left: 1/2" round Bottom Left: 1/4" round Top Right: 1/4" round Bottom Right: 3/8" round