Impression Die Interlocking Leaves

3/8" Wide 17-gauge Sold in 1-ft. lengths This pattern was made during a revival of interest of older southwestern and Native American designs and architecture during the late 1930s.

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

This spacer is 6''  x  8''  and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use metal pieces on lower platen to take up space between platens.

13 1/4" x 1", 16G. This design comes from the Frank Morrow collection and was made in the 1930s in the Art Nouveau style with densely packed engraved scroll work.

1/2" wide