Impression Die Victorian Buckle Amulet

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch squares. Thickness of each piece is 1/4 inch. Note: These will fray, crack and deform with use, but you will get many uses from them.

Have a custom pancake die made for you. The die will not be available for purchase by anyone but you. The order includes 2 pancake dies of the same design. This price is for up to a 2 inch design. Read directions in full description before placing order. BEFORE ordering, be sure to email design to [email protected] so we can be sure it is suited for a pancake die before you pay.

This spacer is 4.5'' x 7.75'' and 1'' thick. Non magnetic Spacers are used in the press to lessen the amount of effort needed to extend the jack and activate the items being used in the press. Top and bottom platens are not meant to touch - it will cause the jack to overextend and cause leaking, or for jack to fail. Always use spacers on lower platen to take up space between platens.

2 inch diameter x 1 inch thick urethane, 90/95 durometer. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.

3 inch diameter x 1 inch thick, 90/95 durometer urethane insert. Can be used with or without a container. If over-squeezed without a container, it will crack. COLOR WILL VARY.