Impression Die Bezeled Seaweed Ring

Bag of 10 pieces of urethane for use with impression dies. 95 durometer sheet. Pieces range from approximately 1/2 inch to 1 inch in length. Thickness of each piece is 1/4 inch.  Note: These will fray, crack and deform with use, but you will get many uses from them.

Bracelet Former Kit to be used with 20 Ton hydraulic press. Our Bracelet Former Frame is now magnetic - no adapter plate needed! Great to use our bracelet pancake dies to cut the metal first, then form with our Bracelet Former Kit, for quick cuff bracelets.

SAME kit as Dremel - One piece of metal (a bushing) is different. Kit includes: Aluminum 6" long koil holder block and steel top plate for holder. Saw blade, guard for Foredom #30 Flexshaft handpiece with adapter bushing, 1 saw arbor to fit 3/8" hole blades. Coils to be cut can be up to 4 inches long and 7/8 inch (22 mm) in outside diameter. Coils may be made of 12 through 30 gauge wire.

6" long, tapered 7/8" to 1 3/4" wide. Square ends. Largest (length and width) of our bracelet dies. Use this bracelet die with any of our bracelet formers.rnSave a step when making a bracelet - just use a pancake die instead of sawing out the blank piece  *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***

Wave bracelet die 6.1/4" long, 1 1/8 inch wide *** THIS DIE WILL NOT FIT IN A MEDIUM PRESS ***