This die must be used in a hydraulic press. 3.70" x 0.27"
This die must be used in a hydraulic press. 3.74" x 0.26"
This die must be used in a hydraulic press. 3.61" x 0.30"
This die must be used in a hydraulic press. 3.63" x 0.26"
This die must be used in a hydraulic press. This die measures 3" x 13/16"
This die must be used in a hydraulic press. This die measures 3 3/8" x 5/8"
Ring is 3 inches wide (long) x .25" thick band with oval section is 1" thick.
3" wide (long) x 7/16" at widest down to 3/16" at narrowest.
Die cutout is 3" long x 7/16" band at narrowest, and 1 1/4" at widest.
Die cutout is 3" long x 1/4" at thinnest and 1 1/2" at widest.
This die is to make a ring shank that then has a 16mm circle opening to place a stone and bezel. At longest tips it is 3 1/8". Skinniest point is 1/4" H, and tallest points (at ends) is 1 1/4" High.
7/8" H (at highest point) x 3 3/8" W Narrowest point is 1/8"